The Sea-Doo Carbon Ring is a critical sealing component in the 4-TEC driveline system. This carbon seal presses against the stainless steel wear ring on the driveshaft to create a watertight seal between the hull and the propulsion system while still allowing the driveshaft to rotate freely.

As the driveshaft spins, the carbon ring maintains constant pressure against the wear ring to prevent water from entering the hull. Over time, the carbon surface naturally wears from friction and heat. If the carbon ring becomes worn, chipped, or damaged, the seal can weaken and allow water intrusion. Replacing the carbon ring restores proper sealing pressure and helps maintain the integrity of the Sea-Doo carbon seal system.

This genuine OEM replacement is commonly installed when servicing the carbon seal assembly, driveshaft, or jet pump and is an important maintenance component for reliable driveline operation.

Features
• Genuine OEM Sea-Doo replacement part
• Creates the watertight seal between the driveshaft and hull
• Maintains proper sealing pressure against the stainless wear ring
• Helps prevent water intrusion caused by worn carbon seals
• Ideal for driveline or carbon seal maintenance

Fits the following Sea-Doo models

GTX Series
2002 GTX 4-TEC
2003 GTX 4-TEC
2003 GTX 4-TEC Supercharged
2003 GTX 4-TEC Wake
2004 GTX 4-TEC
2004 GTX 4-TEC Supercharged
2004 GTX 4-TEC Limited Supercharged
2004 GTX 4-TEC Wake
2005 GTX 4-TEC
2005 GTX 4-TEC Supercharged
2005 GTX 4-TEC Limited SCIC
2005 GTX 4-TEC Wake
2006 GTX 4-TEC
2006 GTX 4-TEC Supercharged
2006 GTX 4-TEC Wake

RXT / RXP Series
2005 RXT
2006 RXT
2007 RXP

GTI Series
2006 GTI STD
2006 GTI SE
2006 GTI Rental
2007 GTI STD
2007 GTI SE
2007 GTI Rental

WAKE Models
2004 WAKE 155
2005 WAKE 155
2006 WAKE 155