ARP2000 rod bolt 3/8" x 1.500"

Includes torque spec for Sea-Doo 4TEC watercraft.

Specifically fabricated for Molnar connecting rods (any aftermarket connecting rods can use these rod bolts, but only these rod bolts should be used on Molnar connecting rods).

ARP2000®: ARP2000 is an steel alloy that can be safely heat treated to a higher level than 8740. While 8740 and ARP2000 share similar characteristics – ARP2000 is capable of achieving a tensile strength of 220,000 psi. Stress corrosion and hydrogen embrittlement are typically not a problem.

INSTRUCTIONS ARE INCLUDED IN THE BOX AND DISPLAYED ON THE PRODUCT PICTURES
Kit includes: 6 bolts, and 1 torque lubricant.


For Sea-Doo 1503 ROTAX 4-TEC 130/155/215/255/260

Applications:

2004-2007 Sea-Doo GTI
2007-2016 Sea-Doo GTI 130
2007 Sea-Doo GTI 150
2007 Sea-Doo GTI 4TEC
2008-2016 Sea-Doo GTI 155
2012-2016 Sea-Doo GTR 215
2011-2016 Sea-Doo GTS 130
2007 Sea-Doo GTX
2007-2016 Sea-Doo GTX 155
2007-2016 Sea-Doo GTX 215
2009 Sea-Doo GTX 255
2010-2016 Sea-Doo GTX 260
2004-2007 Sea-Doo GTX 4TEC
2012-2016 Sea-Doo GTX S 155
2004-2006 Sea-Doo RXP
2007-2008 Sea-Doo RXP 155
2007-2010 Sea-Doo RXP 215
2007-2010 Sea-Doo RXP-X 255
2012-2015 Sea-Doo RXP-X 260
2005-2007 Sea-Doo RXT
2008-2010 Sea-Doo RXT 215
2009 Sea-Doo RXT 255
2009 Sea-Doo RXT 260
2008-2009 Sea-Doo RXT-X 255
2010-2016 Sea-Doo RXT-X 260
2009-2016 Sea-Doo Wake 155
2009-2016 Sea-Doo Wake Pro 215


Cap Screw without Washer – Rod Bolt Installation

1) Make sure there is an adequate chamfer around the bolt hole on the connecting rod cap to clear the radius under the head of the bolt.

2) Use provided lubricant to lubricate the threads of the bolt and the under head of the bolts. Then install the bolts and tighten them hand tight.

3) ARP recommends using the STRETCH METHOD when tightening rod bolts. Following the instructions for using a stretch gauge, stretch the bolts to 0.0070 to 0.0075.

4) If you do not have a stretch gauge, torque the bolts to 60-65 ft-lbs using provided lubricant.

5) The connecting rods should always be re-sized after new rod bolts are installed.

6) A log should be kept on the original non-torqued length of each bolt. Bolts that have any permanent deformation or have increased in non-torqued length by more than .001: should be replaced.